Projects
Our environmental team has worked on a wide variety of projects specializing in implementing regulatory and contractual mitigation requirements on several construction projects. Some of those projects are:
Washington 2015
An electrical utility contractor retained the services of SWP Environmental to ensure environmental compliance during construction of a 28-mile rebuild of a 115 kV wood pole transmission line
Washington 2013-2015
Portland General Electric retained the services of SWP to provide onsite QA/QC and construction
Alaska 2015
An underground infrastructure contractor retained the services of SWP Environmental to develop
Oregon 2014
Cat Track Inc retained SWP to provide an onsite Environmental Compliance Specialist
Washington, 2012-2013
SWP was retained to provide QA/QC and Construction management services
California, 2012
CJ Drilling, Inc (foundation contractor) retained the services of SWP Environmental Services (SWP) to ensure that construction operations were conducted in accordance with the mitigation measures as well as permit conditions on this 500kV transmission line project.
Washington, 2010-2011
This project involved the installation of approximately 1.17 mile-long 115kV secondary transmission line at
Nevada, 2008-2010
The Flamingo UG EPC Project was an overhead to underground conversion project which removed 4500’ of
Washington, 2010-2012
SWP was retained by Puget Sound Energy (PSE) to provide QA/QC and Construction management services
Washington, 2009
An Electrical Utility Contractor retained the services of SWP Environmental to assist with the environmental regulations on a new 20 mile, 230-kV double-circuit, steel lattice transmission line...
Washington, 2008-2010
This 230-kV design/build project for Puget Sound Energy involves constructing 40 miles of transmission line through three different counties, with multiple river and stream crossings, and approximately 22 poles located in wetlands.
Washington, 2008
SWP Environmental Services was retained to provide resource analysis for compliance with NEPA requirements for an electrical utility project...
Washington, 2008
SWP Environmental Services was hired to complete restoration work at areas where crews performed clean up and repaired damaged transmission lines from the December 2007 storm....
Washington, 2007-2008
SWP Environmental Services was retained to acquire environmental permits for a project...
Everett, WA 2007-2008
This design/build project involved replacing 2.1 miles of two transmission lines on parallel wood pole H-frame structures. The lines were replaced with a double-circuit line on single steel poles. The transmission lines are located through wetlands...
Idaho, 2007
An Electrical Utility Contractor retained the services of SWP Environmental Services on multiple environmentally senstivie projects to develop and conduct Environmental Training for the crews